Inspection, Maintenance, And Cleaning - Chicago Electric 95126 Assembly And Operating Instructions Manual

8. CAUTION! Failure to connect and operate appliances, tools, and equipment
in this sequence can cause damage to the Generator, appliances, tools, and
equipment and will void the warranty on this Generator.
9. Once the Engine is running, simply connect the 120 volt appliances, tools, and
equipment into the 120 VAC Outlets (71). Connect a 240 volt appliance, tool, or
equipment into the 240 VAC Outlet (72). Or connect a 12 volt appliance, tool,
or equipment into the 12 VDC Charging Terminal (69). (See Figure B.)
10. IMPORTANT: If Engine speed or voltage fluctuates with a load below 250
Watts, move the Engine Choke Lever (79) to the "HALF-CHOKE" position.
(See Figure B.)
11. When finished using the Generator, disconnect all electrical loads. Close Fuel
Valve (78) until carburetor runs dry, then shut off Ignition Switch (20).
(See Figure B.)

INSPECTION, MAINTENANCE, AND CLEANING

1. WARNING! Always make sure the Engine's Ignition Switch (20) is in its
"OFF" position prior to performing any service, maintenance, or cleaning of the
Generator or Engine. (See Figure B.)
2. Before each use, inspect the general condition of the Generator and Engine.
Check for loose screws, misalignment or binding of moving parts, cracked or
broken parts, loose hose connections, and any other condition that may affect
the safe operation of the Generator and Engine. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Do not use damaged equipment.
3. Generator maintenance:
A. Keep the Generator clean and dry at all times.
B. The Generator should not be operated or stored in locations that include
excessive moisture, dust, flammable or corrosive vapors. If these substances
are on the Generator, clean with a cloth or soft brush.
C. Do not use a garden hose or anything with liquid to clean the Generator.
Liquid may enter the cooling air slots and could damage the interior workings
of the Generator.
SKU 95126 For technical questions, please call 1-800-444-3353 PAGE 14