Operating Instructions - Chicago Electric 95126 Assembly And Operating Instructions Manual

the amount of unleaded gasoline. When necessary, refill the Fuel Tank, only after
Engine is OFF and cooled down.
(See Figure D.)
3. NOTE: Periodically, make sure to check the Fuel Filter (46) for excessive dirt
and debris. If necessary, remove the Fuel Filter and clean with compressed air.
(See Figure D.)
OIL DIPSTICK
FIGURE D
1. Check to make sure the Ignition Switch (20) is in its "OFF" position.
(See Figure B.)
2. CAUTION! Make sure to unplug any load from the Generator before
starting to prevent permanent damage to any appliances, tools, or equipment.
To Start The Engine/Generator:
1. Turn the Engine Fuel Valve (78) to its "OPEN" position. Then, turn the Engine
Choke Lever (79) to its "CHOKE" position. NOTE: No choke is required if the
Engine is warm. Make sure the Engine Choke Lever is in the "RUN" position
when starting a warm Engine. (See Figure B.)
2. Turn the Engine Ignition (2) to its "RUN" position. Grasp the Starter Handle on
the Recoil Starter (75) and pull slowly until resistance is felt. Allow the Rope to
rewind slowly. Then, pull the Handle with a rapid, full arm stroke. Allow the Rope
to rewind slowly. If necessary, repeat this procedure until the Engine starts.
(See Figure B.)
3. When the Engine starts, slowly move the Choke Lever (79) to its "RUN" position.
(See Figure B.)
SKU 95126 For technical questions, please call 1-800-444-3353
(74)

OPERATING INSTRUCTIONS

FUEL
FUEL
TANK FILTER
GAUGE
(43)
(47)
FUEL
FUEL
CAP
(44)
(46)
PAGE 12