Inspection, Cleaning, And Maintenance - Chicago Electric 91213 Operating Instructions Manual

4. Start and run the Engine as previously discussed in this manual.
5. When finished using the Generator, turn the Engine Power Switch (2) to its
"OFF" position. Turn the Fuel Valve (40) to its "OFF" position. Then, discon-
nect the electrical powered tool or equipment from the Generator's DC Terminals
(7). (See Figure H.)
6. After the Engine and Generator have completely cooled, store the Generator in a
safe, clean, dry location (if not already installed in one).
7. NOTE: The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit in
case of an overload. Should an overload occur the Fuse will burn out, causing
the Generator to automatically shut down. In this case, refer to Step #1 in this
section. Then, reset the circuitry system by replacing the burnt Fuse with a new
10 AMP DC Fuse. Restart the Generator and continue powering the remaining
tool or equipment. (See Figure H.)
POSITIVE (+) DC TERMINAL (7)
NEGATIVE (-) DC TERMINAL (7)
FIGURE H

INSPECTION, CLEANING, AND MAINTENANCE

1. CAUTION! Always make sure the Engine Power Switch (2) is in its "OFF"
position. Disconnect the spark plug wire from the engine. And allow suffi-
cient time for the Engine and Generator to completely cool before perform-
ing any inspection, maintenance, or cleaning.
2. Before each use, inspect the general condition of the Generator. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
SKU 91213 PAGE 16
10 AMP
DC FUSE
(9)