Table of Contents
Advertisement
POSITIVE (+) DC TERMINAL (7)
NEGATIVE (-) DC TERMINAL (7)
FIGURE H
When finished using the Generator, turn the Engine Power Switch (2) to its "OFF"
5.
position. Turn the Fuel Valve (40B) to its "OFF" position. Then, disconnect the
electrical powered tool or equipment from the Generator's DC Terminals (7).
(See Figure H.)
6.
After the Engine and Generator have completely cooled, store the Generator in a
safe, clean, dry location (if not already installed in one).
7.
NOTE: The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit
in case of an overload. Should an overload occur the Fuse will burn out, causing
the Generator to automatically shut down. In this case, refer to Step #1 in this
section. Then, reset the circuitry system by replacing the burnt Fuse with a new
10 AMP DC Fuse. Restart the Generator and continue powering the remaining
tool or equipment. (See Figure H.)
INSPECTION, CLEANING, AND MAINTENANCE
CAUTION! Always make sure the Engine Power Switch (2) is in its "OFF" po-
1.
sition. Disconnect the spark plug wire from the engine and allow sufficient
time for the Engine and Generator to completely cool before performing any
inspection, maintenance, or cleaning.
before each use, inspect the general condition of the Generator. Check for loose
2.
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
For technical questions, please call 1-800-444-3353.
SKU 92456
10 AMP
DC FUSE
(9)
Page 16
Advertisement
Table of Contents
