Table of Contents
Advertisement
Proper Wiring
TracVision A5 Wiring Diagram
Vehicle Roof
DC Power
Vehicle Power
Ground
(10-16 VDC)
For detailed system wiring
instructions, refer to the
TracVision A5 Installation Guide .
RF Converter
• If you must cut the antenna cable, terminate the cable with the
supplied Snap-N-Seal
degrade system performance.
• Always use an Augat tool (KVH P/N 19-0242)
to attach F-connectors.
• Do not kink or stress the antenna cable.
• Tighten all connections adequately.
• Use high-quality video cable between receiver and monitor(s).
• Place the RF converter at least 3 feet away from the receiver and
other electronic devices.
Effective April 2004
Subject to change without notice
54-0239
Fuse
To VHF Antenna
VHF
ANTENNA IN
VEHICLE POWER
(10-16 VDC)
RF REMOTE
OUT TO TV
SATELLITE IN
INPUT
COMPOSITE VIDEO
Receiver
To Vehicle Video
(Option 3)
®
F-connector. Low-quality connectors will
TracVision A5 Shop Manual
Antenna
Service/
Maintenance
(Optional)
TO IRD
TO KVH
DIAGNOSTIC PORT 1
ANTENNA
SATELLITE IN
AUDIO R
AUDIO L
VIDEO
TruSurround, SRS and
symbol are trademarks of SRS Labs, Inc.
C AU T I O N
S-VIDEO
This device complies with Part 15J of the FCC rules. Operation is subject to the following two conditions:
(1) This device must not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Product Warranty void if outer casing removed .
KVH ® is a registered trademark of KVH Industries, Inc. HUGHES ™ is a trademark of Hughes Electronics Corporation.
To Vehicle Video
(Option 2)
To Vehicle Video
To Vehicle Video
(Option 1)
(Option 1)
To Vehicle
Audio
© 2004 KVH Industries, Inc., All rights reserved.
Only
DIAGNOSTIC PORT 2
TO VIDEO
Augat Tool
Advertisement
Table of Contents
