Datamax E-Class Mark III Operator's Manual page 53

Wired Ethernet Settings Page
Acquire Address
Method
Acquire Address Method
Static IP Settings
Printer IP Address
Printer Subnet Mask
Printer Gateway
Primary DNS Server
Secondary DNS Server
Primary WINS Server
Secondary DNS Server
Ethernet Port
Connection Settings
Duplex Capability
Printers DNS Name
Printers DNS Name
NetBIOS Settings
NetBIOS Enable
NetBIOS Name
TCP Print Services
TCP Print Port
Inactivity Time (seconds)
LPD Print Port
LPD Print Port
UDP Management Port
UDP Management Port
Appendix B – Ethernet Setup
Controls IP Address discovery, where:
Use DHCP: Broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway are
not allowed; and, if no server is found, the specified static value will be used.
Use Static Addresses: Uses the stored static IP, Subnet Mask, and / or Gateway
Address.
These are the static address the printer will use when Acquire Address Method is set to
"Use Static Addresses" or a valid IP could not be retrieved from a DHCP server.
Allows the User to specify the line duplex and speed of the wired Ethernet connection.
Auto-Negotiate (default)
100 BaseT Full Duplex
100 BaseT Half Duplex
Sets the DNS name of the printer.
Enables/Disables NetBIOS, where:
Enables NetBIOS
Disables NetBIOS
Is the name used to reference the printer instead of the IP address. A WINS or DNS
server is required for this capability.
Selects the Port to use for all network communications; the default is 9100.
Sets the time-out (inactivity) threshold in seconds
Sets the LPD printer port; the default is 515
Sets the UDP printer port; the default is 9200
10 BaseT Full Duplex
10 BaseT Half Duplex
47