Martin EFX500 User Manual page 28

Important! Use only this type of lamp. See "Accessories" on page 51 for
details of replacement lamps. Installing any other lamp may
damage the fixture.
Installing a halogen lamp
1. Disconnect the fixture
from power and allow it to
cool for at least 10
minutes.
2. Loosen the lamp cover
release thumbscrew
enough to slide and lift the
lamp cover out of the
fixture housing. The lamp
cover is attached to the
housing with a safety
strap.
3. If replacing an old lamp,
remove it together with its
ceramic socket from the
lampholder clip and, being
careful not to strain any wires, gently pull the lamp off the socket.
4. Hold the new lamp by its base (do not touch any other part of the lamp).
Push the lamp pins squarely into the ceramic socket.
5. If you touched the bulb, the reflector or any optical components, clean
them with a clean, soft, lint-free cloth wetted with isopropyl alcohol and
dry with a clean, soft, lint-free cloth or compressed air.
6. Replace the lamp and socket in the lampholder clip, ensuring that the
reflector sits flat against its plate and is held securely in place. When
installed correctly, the rim of the reflector locates under the heads of
two stop screws so that the reflector is held firmly between these
screws and the lampholder clip.
7. Close the lamp cover, checking that no wires are trapped, and retighten
the thumbscrew.
Discharge lamp (EFX 600, EFX700 & EFX800)
The Mania EFX600, EFX700 and EFX800 use a 150 watt long-life
discharge lamp.
For optimum lamp life, always allow discharge lamps to warm up for at
least 5 minutes before dousing.
28 Mania EFX user manual