Denon DMD-F101 Operating Instructions Manual page 28

3. Undoing the last editing operation
• With this function you can undo the editing operation last performed and reset the settings to as they were one step
before that point. This comes in handy if you make a mistake when editing.
5
(Main unit)
POWER LOADING MECHANISM
ON / STANDBY
18T r0 2 m 4 6 s
1 L
dB -60 40 -30 -20 -12 -6 -2 0
R
In the stop mode, press the EDIT button.
1
• " Edit Mode " is displayed.
Either turn the jog dial on the main unit or press one of the automatic search buttons (
remote control unit.
• Display " Undo? ".
• One of the following messages appears, depending on the type of editing operation last performed:
* When a track or disc title has been input or changed
* When a track title, disc title, a single track, all tracks or part of a track has been erased
* When a track has been divided
* When tracks have been combined
* When the move or program move function has been used / " Move Undo? "
* When a group has been changed or deleted
2
* When the group name was not edited when the group was created
• "CC Undo? " is not displayed if no editing operation has been performed or if the undo operation is not
possible.
• The UNDO function cannot be used in the following cases:
* Once the TOC data has been rewritten
* Once you have recorded or edited something new
* After a power failure
* After the UNDO operation has been used once
* When a title has been input in a mode other than the stop mode
* When the disc recovery function has been used
Press the ENTER button.
3
• " Undo OK? " is displayed.
28
(Remote control unit)
M
EJECT POWER
5
1 2 3
1
4 5 6
7 8 9
1 3
10 +10 CALL
CLEAR GROUP
2
INPUT MEMO REC / EDIT CD SRS MULTI REC
CHARACTER
PROG/
- + DIRECT
REC LEVEL
/ ENTER
MINIDISC RECORDER DMD-F101
REPEAT RANDOM EDIT ENTER
TITLE CHARACTER TIME
2~4
REMOTE CONTROL UNIT RC-282
and
8
/ " Name Undo? "
/ " Erase Undo? "
/ " Divide Undo? "
/ " Combine Undo? "
/ " Group Undo? "
/ " Group Undo? "
3,4
1
Press the ENTER button to clear the editing.
4
• " Complete " is displayed.
) on the Press the 5 (eject) button.
9
• The TOC data is written and the disc is ejected.
• When TOC writing starts, the "
cord while the TOC is being written. If the data is not recorded properly, it will not be possible to play the
5
disc.
• The TOC data can also be recorded by performing the following operations:
• Pressing the power button to set the power to the standby mode.
• Pressing the (stop) button in the stop mode.
2
• To set back to the previous setting, press the CLEAR button.
• To cancel the undo operation, press the
" indicator flashes. Do not shake the main unit or unplug the power
(stop) or CLEAR button before step 4.
2