San Management Software Configuration - Sanit Fs - Accusys ExaSAN SW16 User Manual

When users click "Temperature" icon, the web GUI would pop up a window as following

4.6 SAN management software configuration - SANit FS

If you choose SANit FS to be your SAN management software, please follow the steps
below to configure your SAN environment. For more detailed info like setting up a MDC,
please refer to the user's manual of SANit.
After you type the IP address in your web browser to go to the SANit configuration
menu in the MDC, you should see the screen shot as figure 71. Please select Language
first, and then enter User Name (Default user name is admin) and Password (Default
password is 00000000,"eight zeros"), and then click Log In. See below.
Note
User cannot change the default user name but password. If you
forget your changed password, you could push the reset button in
back of the SW16 for 13 seconds to go back the default setting.
Please refer to the section 1.4.1.4 for more detailed info.
Caution:
If you push reset hold but not disconnected the all clients, you might
damage your important data in the SAN environment.
Active SANit
Step 1: Import license. See section 4.6.1
User Guide
Figure 69: FAN speed and status
Figure 70: Temperature
Figure 71: login SANit FS
4. How to Use
Page 4-19