Connecting The Switch Lan And Power Cord; Figure 20: Connecting The Pcie Qsfp Cable To The Client Port; Figure 21: Connecting The Ethernet Cable To Eth0 And Eth1; Figure 22: Connecting The Power Cords To The Power Supply Module - Accusys ExaSAN SW16 User Manual

3.1.4 Connecting the switch LAN and power cord

1. Insert the Ethernet cable into eth0 (management port) and eth1 (private port for
MDC) on the SW16. The default IP addresses are 192.168.0.25 and 192.168.1.25.,
respectively.
2. After connecting the Ethernet cables, please connect the power cords to the both
power supply modules.

Figure 22: Connecting the power cords to the power supply module

Note
User Guide

Figure 20: Connecting the PCIe QSFP cable to the client port

Figure 21: Connecting the Ethernet cable to eth0 and eth1

3. Installation
Page 3-5