9
Reserve port
10
Power supply module
1.4.2 ExaSAN QSFP Host Bus Adapter (HBA) and LED Indicators
No.
Name
1
QSFP Connector Port
Jumper Switch LED
2
Indicator
User Guide
This QSFP port is reserved.
Connects to power sources with two
power cord to the redundant modules. If
one power failed, the SW16 can still work
normally.
Figure 11: HBA LED indicators
Description
For connection with one of the Host
Module Ports on the switch rear panel or
B08S2-PS directly.
Off (no light at all) indicates the
•
jumper pin in question is set to "On"
position. In this state, the card is
ready for DAS direct connection
with ExaSAN storages, "A12S2-PS or
B08S2-PS".
Solid amber indicates the jumper pin
•
in question is set to "1" position. In
this state, the HBA card is ready for a
SAN connection. See Section 3.1.2,
"Installing the HBA Card," for
additional information.
1. Introduction
Page 1-14