CHECKING LUBRICANT LEVEL AND REFILLING GEARCASE
1.
Place outboard in a vertical operating position.
2.
Remove vent plug from vent hole.
3.
Place lubricant tube into the fill hole and add lubricant until it appears at the vent hole.
IMPORTANT: Replace sealing washers if damaged.
4.
Stop adding lubricant. Install the vent plug and sealing washer before removing the lubricant tube.
5.
Remove lubricant tube and reinstall cleaned fill/drain plug and sealing washer.
Checking Power Tilt Fluid
1.
Tilt outboard to the full up position and engage the tilt lock lever.
MAINTENANCE
66
ob01191
ob01192