Using The Toilet; Emptying; Cleaning And Maintenance - Bailey Approach Advance Owner's Manual

FITTED EQUIPMENT – THETFORD C262 TOILET
Close the access door and lock it. Your
Thetford toilet is now ready to use.
• Never use force if you cannot get the tank
back into place easily. This may cause
serious damage. If blockage occurs, always
check that the blade handle is in the correct
position.
• For toilets with own flush-water tank: open
the water filling door and fill the flush-water
tank with the correct dosage of Aqua Rinse.
This Thetford toilet fluid keeps the flush
water fresh and improves the flushing. Next,
fill up the flush-water tank with clean water
(approximately 8 litres) using a watering
can or hose. Your toilet is now ready to use.
Using the toilet (standard)
• Turn the bowl to the desired position with
the lid closed and using both hands.
• To activate the control panel, press the
flush-button once. The control panel display
will stay activated for approximately 5
minutes. Run some water into the bowl by
pressing the flush button again briefly.
• The toilet may be used with the blade open
or closed. To open the blade, slide the blade
handle under the toilet bowl sideways. After
use, open the blade (if still closed) and flush
the toilet by pressing the flush button for
several seconds (if necessary re-activate
the control panel). Close the blade after
use. If your toilet has its own flush-water
tank, please make sure that you do not
travel with a flush-water tank that is too
full. Do not travel with water in the toilet
bowl. Failure to adhere to this notice may
result in water damage to your motorhome.

Emptying

• The waste holding tank has a capacity of
18 litres and requires emptying when the
red light (LED) on the toilet control display
lights up. At that point the waste holding
tank only has capacity for two more litres
which is no more than two to three further
uses.
• Place the waste holding tank in an upright
position (pull-out handle at the top, wheels
at the bottom). slide the handle sideways –
to the front of the tank – until it snaps out
of its locked position. Pull the handle up
and wheel the waste holding tank to an
authorised waste disposal point. Push the
handle back into its locked position. Turn
the emptying spout upwards and remove
the cap from the spout. Hold the waste
holding tank in such a way that during
emptying you can operate the vent plunger
with your thumb. To empty the tank without
splashing, depress the vent plunger while
emptying the tank. After emptying, rinse
the tank and blade thoroughly with water.
• Do not vigorously shake the tank or use
high pressure water cleaners. This may
cause damage to the tank's interior.
• The vent plunger should only be depressed
once the emptying spout is pointing
downwards. Prepare the toilet for re-use if
required. Slide the waste holding tank into
the toilet and close the access door.
Emptying with Optional Features
• Waste holding tank multi-level indicator:
The lower lamp indicates that the waste
holding tank is almost empty; the middle
lamp indicates that it is more than half full;
when the upper lamp lights up, the tank
needs emptying as it can only take two to
three further uses.
• The waste holding tank level Indicator will
flash when the holding tank is not present.
In this case the toilet will not flush.

Cleaning and Maintenance

• The toilet should be cleaned and maintained
regularly, depending on the amount of use.
To clean Thetford toilets, we advise using
water and Thetford Bathroom Cleaner.
Never use bleach, vinegar or other powerful
household cleaners that contain these
substances. These may cause permanent
damage to the seals and other toilet
components.
Motorhome Equipment
Toilet Bowl
• Squirt Thetford Bathroom Cleaner into the
toilet bowl.
• Flush the toilet bowl with water and wipe
down the rest of the toilet with a damp
cloth.
• Clean seat and lid. The seat and lid can
easily be removed: lift the seat and lid
assembly and pull the round pins (inside
the assembly) outwards from the pin holes.
After cleaning, replace the seat and lid by
positioning the round pins in front of the pin
holes and push the lid and seat downwards.
• To keep your flush water fresh and to
prevent deposits forming in your toilet
bowl, add a correct dosage of Aqua Rinse in
your flush-water tank.
• Tip! For a really shining toilet, dry with a
soft dry cloth after cleaning.