Bailey Approach Advance Owner's Manual page 51

FITTED EQUIPMENT – The Control Panel
Icon Mode Description
Electric To operate
h i g h heater on electric
only high setting only
Electric To operate
low only heater on electric
low setting only
H e a t e r To turn the heater
off off completely
G a s To operate
or
function heater on gas only
Gas and To operate on gas
or
electric and electric low
low
Gas and To operate on gas
or
electric and electric high
high
Press to set the heater mode.
On all gas settings a filled flame
that the gas is currently burning. An empty
flame shows that gas is selected but not
burning. A flame icon on the homepage will
also indicate that a gas appliance is currently
in use.
Note: Please consult the Whale user manual
for more detailed information on each mode.
Water Level
The level in the fresh water tank is
displayed as a % on this screen.
Note: See "Notifications
Warnings" section for water low
warning and "User Settings" section for water
low alarm enable.
the
Waste Level
The level in the waste water tank is
displayed as a % on this screen.
the
Note: See "Notifications and Warnings" section
for waste high warning and "User Settings"
section for waste high alarm enable.
the
Fill Internal Tank?
With the external pump connected to
the inlet and to an external water
source, press to fill the internal
tank.
Note: When the internal tank is full the pump
will stop automatically.
External Temperature
The outside temperature, as detected
represents
by a sensor underneath the van, is
displayed on this screen.
You can change between degrees
Celsius and degrees Fahrenheit by
pressing
for °F.
Internal Temperature
The inside temperature, is detected
by a sensor inside the control panel,
is displayed on this screen.
You can
and
and degrees
Select Battery
Press
If the "Auto-Battery" feature is enabled (see
"User Settings" section) the system will
automatically switch to "Vehicle Battery" if
the "Leisure Battery Voltage" is low (less than
11V).
When 230V mains is connected "Leisure
Battery" is automatically selected and cannot
be changed.
Note: See "Notifications and Warnings" section
for vehicle battery notification.
Leisure Battery Amps
and selecting for °C or
To display current draw as a percentage press
displaying in Amps by pressing
Note: See "Notifications and Warnings" section
for High current warning and "User Settings"
change between °C
section for amps high alarm enable.
°F by pressing
and selecting for °C or
With 230V mains
disconnected, the user can
choose to draw power from
the leisure battery OR the
vehicle battery.
to swap between batteries.
The current being drawn from your
leisure battery, in Amps, is displayed
on this screen. A higher current will
drain your battery faster.
then . 12A reads 100%. You can return to
for °F.
then .