Preparing For Use (Standard); Preparing For Use With Optional Features; Using The Toilet (Standard) - Bailey Caravan Owner's Manual

4.13.2 Preparing for use (standard)

1. Open the access door on the outside of your caravan or camper.
2. Remove the Waste Holding Tank by pulling the safety catch (which holds the tank in place) upwards.
3. Pull the Waste Holding Tank outward to the stop. Tip it slightly and take the tank fully out.
4. Place the tank upright and turn the rotating emptying spout upwards. The emptying spout ensures
that the tank can be easily and hygienically emptied.
5. Remove the cap, with the measuring cup inside, from the emptying spout and pour the correct
dosage of Thetford toilet fluid (see product label) into the holding tank. This avoids unpleasant
smells and keeps the inside of the tank clean. Next add approximately 2 litres of water - enough to
ensure that the bottom of the Waste Holding Tank is covered. Far more information on Thetford
toilet fluids, see last page of this manual. Screw the cap back onto the emptying spout and turn
back to its original position.
▲ The Emptying Spout Measuring Cap is supplied in the same packaging as this manual.
▲ Never add toilet fluid directly via the blade or the toilet bowl as this could damage the lip
seal of the Waste Holding Tank. Always pour the fluids via the emptying spout.
6. Slide the Waste Holding Tank back into its original position via the access door. Make sure that it
is secured with the safety catch. Close the access door and lock it. Your Thetford toilet is now
ready to use.
▲ Never use force if you cannot get the tank back into place easily. This may cause serious
damage. If blockage occurs, always check if the blade handle is in the correct (closed)
position.
7. For toilets with own Flush-Water Tank: Open the water filling door and fill the flush-water tank with
the correct dosage of Aqua Rinse. This Thetford toilet fluid keeps the flush water fresh and improves
the flushing. Next, fill up the flush-water tank with clean water (approximately 8 litres) using a ferry
can or hose. Your toilet is now ready to use.

4.13.3 Preparing for use with Optional Features

8. Automatic Ventilator: Open the access door on the outside of your caravan and remove the Waste
Holding Tank (as described above).
9. Remove the filter housing cover and if no filter is present, place a new filter into the filter housing.
Peel off the sticker lids on the filter. Place back the cover of the filter housing.

4.13.4 Using the toilet (standard)

10. Turn the bowl to the desired position with the lid closed and using both hands.
11. To activate the control panel, press the flush-button once. The control panel display will stay activated
for approximately 5 minutes. Run some water into the bowl by pressing the flush button again
briefly.
12. The toilet may be used with the blade open or closed. To open the blade, slide the blade handle
under the toilet bowl sideways. After use, open the blade (if still closed) and flush the toilet by
Caravan Equipment
4
4-37