Bailey Approach Advance Owner's Manual page 65

FITTED EQUIPMENT- The Alde Heating System
"Overheat red fail" or "Overheat blue fail"
• Bleed the system of air.
• Check the fluid level in the expansion tank.
It should be 1cm above min mark when cool.
• Check the circulation pump is responding.
• Wait 15 mins for the fluid to cool down.
"Overheat PCB"
• Failsafe in boiler has triggered.
• Check the fluid level in the expansion tank.
It should be 1 cm above the Min mark when
cool.
• Check the boiler compartment is ventilated,
and that the vents are unobstructed. Do not
place stowage in the boiler compartment.
"Fan failure"
• Combustion fan speed too low. Bearing may
be stiff after a period of disuse.
• Automatically clears after 5 mins. Please
try again.
"Connection failure"
• Loose connection between Alde control
panel and boiler.
• Unplug cable at the control panel and boiler,
then carefully plug back in.
• Check there is slack on the cable at the
control panel, but not excessive weight
from free-hanging/unmanaged cable.
"Window open"
• Optional window sensor has triggered, gas
heating is suspended. Automatically clears
and gas heating resumes when window is
closed.
"Connection fail ext"
• Break in communications between Alde
control panel and daisy-chained third party
control panel.
• Check the cable between the Alde control
panel and third party control panel.
"Low battery"
• 12v supply to boiler has dropped below
10.5v, possibly causing system brownout.
• Automatically clears when 12v supply
reaches 11v.
"No match Heater/Panel"
• Control panel is incompatible with boiler
PCB.
• Check control panel part number. Control
panel 3020-013 is for 3020 A-series boiler,
3020-113 is for 3020 HE-series boiler.
If problems persist, please contact Alde, or
your dealer or installer.
For frequently asked questions, or download
all instruction manuals, please visit Alde's web
site at:
www.alde.co.uk