Stainless Steel Sink; Tecnoform Doors And Worktops - Bailey Approach Advance Owner's Manual

STAINLESS STEEL SINK

Stainless steel sinks need little maintenance
other than cleaning immediately after use.
Most deposits can be removed by washing with
soap or mild detergent and hot water, followed
by a clean water rinse and drying with a soft
cloth to prevent water spotting.
For more tenacious deposits a non-abrasive
multi-purpose cream cleaner such as CIF
should be used, followed by a clean water rinse
and drying.
Tannin stains can be removed by a solution of
washing soda and water applied with a soft
cloth/sponge followed by a clean water rinse
to remove any residues and drying with a soft
cloth.
(When cleaning with anything other than water
be careful not to get the solution onto your
kitchen worktop.)
Scratching will be most noticeable on highly
polished components. These marks are usually
only superficial and can be removed with a
proprietary stainless steel cleaner/polish. A
useful alternative is a car paint restorer, such
as "T-Cut". If the surface has a directional
polished grain always clean along the grain and
not across it.
Always avoid bleach and trigger dispense
products and never use wire wool or leave wet
cloths, pads or containers on the surface as
they may form water marks.
To preserve the appearance of your
!
appliance we recommend plastic bowls
or mats are not stored in the sink. This
is particularly the case when travelling
because vehicle movement may cause
the plastic bowl to vibrate/rub against
the surface and leave marks.
FITTED EQUIPMENT - GENERAL

TECNOFORM DOORS AND WORKTOPS

Wipe the doors with a soft, slightly damp cloth
(not wet) and then dry them with a dry cloth.
Worktops can be wiped with a wet cloth and are
more resistant to water than the locker doors.
Gasoline, benzene, thinners, any abrasive
products, chemically treated dust cloths and
detergents may damage the doors and should
not be used.
6