Introduction; Parts; Preparing For Use - Bailey Approach Advance Owner's Manual

THE THETFORD C262 TOILET

Introduction

The Thetford Cassette Toilet is a high quality
product. The toilet forms an integral part
of your motorhome bathroom, thanks to its
functional design which combines modern
styling and ease of use.
The C-262 Cassette Toilet is manufactured
from high quality synthetic materials which
makes it a durable, user and maintenance
friendly toilet.
The toilet is made up of two parts: a
permanently fixed part and a waste holding
tank that is accessible from the outside. The
removable waste holding tank is located under
the toilet bowl and can be removed via a door
on the outside of the motorhome.
The operating instructions cover Thetford
Cassette Toilet C262 CWE.

Parts

1. Cover
2. Seat
3. Swivelling toilet bowl
4. Blade handle to open and close blade
5. Control panel
5b.Waste holding tank level indicator
6. Pull handle
7. Pour out spout
8. Cap with measuring cup
9. Automatic pressure release vent
10. Vent button
11. Sliding cover
12. Blade opener
13. Waste holding tank mechanism
14. Wheel
15. Service door
16. Water fill door
FITTED EQUIPMENT – THETFORD C262 TOILET
17. Console with flush water tank
18. Filter for electric ventilator
19. Location waste pump-out system
Preparing for use (standard)
• Open the access door on the outside of your
motorhome.
• Remove the waste holding tank by pulling
the safety catch (which holds the tank in
place) upwards.
• Pull the waste holding tank outward to the
stop. Tip it slightly and take the tank fully
out.
• Place the tank upright and turn the rotating
emptying spout upwards. The emptying
spout ensures that the tank can be easily
and hygienically emptied.
• Remove the cap, with the measuring cup
inside, from the emptying spout and pour
the correct dosage of Thetford toilet fluid
(see product label) into the holding tank.
This avoids unpleasant smells and keeps
the inside of the tank clean. Next add
approximately 2 litres of water – enough
to ensure that the bottom of the waste
holding tank is covered. Screw the cap back
onto the emptying spout and turn back to
its original position. The emptying spout
measuring cup is supplied inside the toilet.
Never add toilet fluid directly via the blade
or the toilet bowl as this could damage the
lip seal of the waste holding tank. Always
pour the fluids via the emptying spout. The
lip seal is the water tight seal around the
top of the tank.
• Slide the waste holding tank back into its
original position via the access door. Make
sure that it is secured with the safety catch.
6