Front Panel Description - Krell Industries KCT Instructions For Use Manual

Front Panel Description

See Figure 1 on page 8
The KCT preamplifier front panel provides power on, input and zone selection, level
control, menu functions, and status display. Front panel features and their descriptions
follow.
Power
1 Power Button
Use this button to switch the KCT between the stand-by and the operational modes.
2 Stand-by LED
The red stand-by LED illuminates when the KCT is plugged into a standard AC wall
receptacle, indicating that the KCT is ready to be switched to the operational mode.
3 Power LED
The blue power LED illuminates when the KCT is in the operational mode and flashes
when remote control signals are received.
Remote Control Functions
4 Infrared Sensor
The infrared sensor receives commands from the KCT remote control. For proper
remote control operation, make sure the infrared sensor is not covered or obstructed.
5 Infrared Transmitter LED
The infrared transmitter LED flashes when the KCT sends infrared signals to another
remote control. See Program Remote Menu, on page 31.
Preamplifier Functions
6 Input Select Buttons
Use these buttons to select the corresponding rear panel input that is connected to a
CAST (C-1, C-2), balanced (B-1, B-2), or single-ended (S-1, S-2, S-3) analog source.
The front panel display (13) shows the active zone, the selected input, and volume
level.
7 Tape Button
Use this button to select the corresponding rear panel input that is connected to a
analog tape source. When is activated, the front panel display (13) shows the zone
TAPE
that is the pathway for the tape output. See Tape Output Menu, on page 30.
8 Mute Button
Use this button to mute the preamplifier output. To unmute, press the mute button
again. To customize mute button operation, see Mute Menu, on page 29.
Krell Current Tunnel 9