One-Off Setting Before And During Preparation; Entering A Default Setting For The Amount Of Water For A Cup Size; Cappuccino With The Professional Cappuccino Frother - Jura ENA3 User Instruction Manual

ENA 3
One-off setting before and during
preparation
The coffee strength can be changed before
preparation or during the grinding operation.
The following coffee strength options are possible
for 1 coffee:
Z
Mild
Z
Normal
Z
Strong
E
2 coffees are always prepared with the
coffee strength 'mild'.
E
The pre-set amount of water can be
changed during the brewing operation by
turning the Rotary Switch.
One-off settings before and during coffee
preparation always follow this model. These
settings are not saved.
Example: Changing the coffee strength of
1 coffee before preparation from
to .
STRONG
Precondition:
READY
T
Place the cup under the coffee spout.
g T
Turn the Rotary Switch until
displayed.
k T
Press the Rotary Switch until
displayed.
During grinding the coffee strength
is displayed.
STRONG
, the pre-set amount of water
1 CUP
flows into the cup, preparation stops
automatically.
READY
Entering a default setting for the amount of
water for a cup size
E
A default setting can be entered for the
amount of water for 1 coffee. When
preparing 2 coffees this amount is
dispensed per cup.
18
NORMAL
is shown on the display.
STRONG
STRONG
Precondition:
T
Place the cup under the coffee spout.
k T
Press the Rotary Switch and hold it down.
During grinding the strength of the coffee
is displayed.
k T
Continue to hold the Rotary Switch down
until
ENOUGH COFFEE ?
The coffee flows into the cup.
k T
Press the Rotary Switch again when enough
coffee has been filled into the cup.
, the default setting for the amount of
OK
water for one coffee has been entered.
READY
E
This setting can be changed at any time by
repeating the above procedure.
Cappuccino with the
Professional Cappuccino Frother
Precondition:
T
Remove the protective cover from the
Professional Cappuccino Frother.
T
Connect the milk pipe to the nozzle.
T
Insert the other end of the milk pipe into a
milk carton or connect it to a milk
is container.
T
Place a cup under the nozzle.
T
is Set the selector lever of the nozzle to the
milk foam
g T
Turn the Rotary Switch until
displayed.
k T
Press the Rotary Switch.
HEATING
READY
sufficiently heated.
is shown on the display.
READY
is shown on the display.
READY
p
position.
STEAM
appears as soon as the ENA is
appears.
is