M86 Security IR Web Filter User Manual page 166

G A
LOBAL DMINISTRATOR
144
S C 1: S
ECTION HAPTER
NOTE: If a source server is set up with a NAT device, the NAT IP
address must be used instead of the source server's own IP
address.
3. Click Test Source to open an alert box that provides the
server mode status for the IP address you entered.
4. Click OK to close the alert box, and make any adjust-
ments, if necessary.
5. After validating the source IP address, click Change
Source to display this IP address in the Current Source
IP display field.
6. Click Apply after all settings have been made.
NOTE: This test only verifies whether this server can contact the
source server. In order for synchronization to be operable on the
network, the source server must also be able to contact this
target server being configured.
YSTEM SCREEN
M86 S U G
ECURITY SER UIDE