M86 Security IR Web Filter User Manual page 163

• The mobile mode cannot be used
• If "Library" Selective Synchronization is enabled, end users for
the failed Web Filter "node" might be given the Global Group
Profile instead of their active filtering profiles
• If a target server fails, the Range to Detect Settings window
displays a Node tab with IP range information for the failed
"downstream" server.
4. In the IP to Send frame, select either the LAN 1 or LAN 2
NOTE: LAN 1 and LAN 2 IP addresses that display in this menu
were previously entered in the LAN Settings window on this
server.
5. In the Target IPs frame, enter the Target IP address of
NOTE: If a target server is set up with a NAT device, the NAT IP
address must be used instead of the target server's own IP
address.
6. An entry in the Target Location field is optional. This
7. Click Add Target IP to include this IP address—and
M86 S U G
ECURITY SER UIDE
G
LOBAL
IP address from the IP to Send pull-down menu. This IP
address will be used for sending profile/library setting
changes to the target server(s).
the Web Filter that will receive profile/library setting
changes from this server being configured.
alphanumeric entry serves as a label for readily identi-
fying the server being configured.
corresponding Location information, if applicable—in the
list box.
The following optional steps can be performed:
• Follow steps 5 to 7 for each server that should receive
profile/library setting changes from this server being
configured.
• Click Test Target(s) to open an alert box that provides
the server mode status for each IP address you
entered. Click OK to close the alert box, and make any
adjustments, if necessary.
A S
DMINISTRATOR ECTION
C 1: S
HAPTER YSTEM SCREEN
141