Control Panel; Installation - Elation TVL1000 User Instructions

TVL1000
5-Pin XLR DMX Connectors.
connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures
may be implemented in a 3-pin XLR DMX line. When inserting stan-
dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be
used, these adaptors are readily available at most electric stores. The
chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor 3-Pin XLR Female (Out)
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
TVL1000
The TVL1000 is fully operational in three different mounting positions,
hanging upside-down from a ceiling, hanging sideways on truss-
ing, or set on a flat level surface. The unit should be mounted using
a mounting clamp (not provided), affixing it to the mounting bracket
that is provided with the unit. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure
that the structure to which you are attaching the unit is secure and is
able to support a weight of 10 times the unit's weight. Also, always
use a safety cable that can hold 12 times the weight of the unit when
installing the fixture.
The equipment must be installed by a professional, and it must be
installed in a place where it is out of the reach of people's grasp.
©Elation Pr fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 7
o
Some manufactures use 5-pin XLR
5-Pin XLR Male (In)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 - Do Not Use
Pin 5 - Do Not Use

Installation

Set Up TVL1000
1 Display: To show the various menus and the selected functions
2 Indicator LED: First make sure to turn on the battery switch.
DMX
MASTER
SLAVE
BATTERY
Note: Connect the fixture to a main power supply. If the battery indicator
blinks slowly, it means the battery is being charged. When the indicator
stops blinking and stays lit, it means the battery is at full charge.
When using the battery power, the indicator light will not bet lit. If the
remaining battery power is less then 16%, the indicator will blink fast
reminding you that the battery is low and that it needs to be charged.
3 Button:
MENU
DOWN
UP
ENTER
4 Dimmer adjust knob: Adjust lightness for the unit from 0~100.
5 Color temperature adjustment: Adjust the color temperature from 3200k to 6500k,
6 DMX output: For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.
7 DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal
8 Main input: Connect to main power supply.
9 Main output: Connect to the main power ofthe next unit.
Battery switch: Turn on or turn off the switch for battery mode. This switch can only
control battery.
©Elation Pr fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 8
o
On DMX input present
On Master Mode
On Slave Mode
On Battery is full
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions
25K as a step.

Control Panel