Mini-Mixer Configuration; Status Led - Intelix Psychologist User Manual

Mini-Mixer Configuration

Status LED

An LED near the master knob (see page 15) indicates the status of the Mini-Mixer. The output
of the LED indicates the status of the Mini-Mixer.
Steady On The Mini-Mixer is powered up and communicating with the Matrix. This is the
normal condition.
Flashing A flashing LED indicates an abnormal status. The rate of flashing indicates the
problem.
• Slow (50% duty cycle) - The Mini-Mixer is powered on but has lost communication with the
Matrix.
• Repeating single flash (every 2 seconds) - The Mini-Mixer is powered on but has not estab-
lished communication with the Matrix.
• Repeating double flash (every 2 seconds) - The Mini-Mixer has been commanded to go to
set-up mode by the Matrix Mixer. This state is normally active for a short duration when new
remotes are plugged into the system and then changes to the normal, steady on condition.
• Fast flash (50% duty cycle) - The Mini-Mixer has conflicting output address assignments.
Initial conflict may disappear as the system continues its initialization procedure. This could be
caused by two Mini-Mixers having the same assignment, if stereo assignments overlap, or if assign-
ments are outside the range of the Matrix Mixer (including 00). To correct, change output selectors
of one of the two remotes with overlapping assignments.
Steady Off
never blinks following powering, there is either no power to the remote, or a fault in its electronics.
For troubleshooting help, see Troubleshooting Tips on page 27.
Psychologist Mixer User Manual
The unit doesn't have power. Check the power supply. However, if the LED
Psychologist Mixer User Manual
17