Adding Mini-Mixers - Intelix Psychologist User Manual

Adding Mini-Mixers

Follow the steps below to add Mini-Mixers or reconfigure your system.
1. Determine which audio output locations are to be controlled by each Mini-Mixer.
Each Mini-Mixer must have a unique output location assignment on the Matrix Mixer. Mono Mini-
Mixers use a single output location. For example, if you install a new 8/1 Mini-Mixer at output
location 06, the next new Mini-Mixer would go at output location 07.
Stereo Mini-Mixers use two consecutive outputs on the Matrix Mixer; the location it is set for and
the next higher output location. For example, if you install a new 8/2 Mini-Mixer at output 06, it
would control outputs 06 and 07. The next new Mini-Mixer would be set for output 08.
2. Set the rotary switch on the Mini-Mixer to the correct output assignment.
Insert a small screwdriver into the holes in the bottom of the unit and turn the rotary switches to the
correct matrix output assignment for that Mini-Mixer. The output assignment is a regular (1-based)
decimal number, so 01 is output one and 16 is sixteen, and so on. The output range is from 01 to 99.
3. Install the new Mini-Mixer to the system.
Connect the Mini-Mixer using the appropriate length of PC cable. Connect each Mini-Mixer one at a time.
The Matrix will recognize the new Mini-Mixer within about a minute. Verify that the Mini-Mixer is powered
up and communicating with the Matrix Mixer, as indicated by a steady-on status LED, before connecting
the next Mini-Mixer.
26
Psychologist Mixer User Manual
Psychologist Mixer User Manual