Mini-Mixer Remote Controllers - Intelix Psychologist User Manual

Psychologist Mixer User Manual
down) in installations which include a permanent RS232 controller such as AMX, Crestron or custom PC
program.
Note: After changing any DIP switches, you must resest the matrix by pressing the reset button on
the rear panel. Changes will not take place unless you reset the matrix.
Reset the Matrix Mixer memory.
Resetting the Matrix Mixer memory will cause the Matrix Mixer to look for and re-establish commu-
nications with all of the Mini-Mixers. This solves most system problems. To reset the memory,
locate the DIP switch on the rear panel of the Matrix Mixer and note the position of the switches. Set
switches 1, 2 and 8 to up, all others down, as shown in the illustration below. This clears the
memory. Then return the switches to their original positions.
Unused switches
Switches 1,2,3,4 and 8 are unused except as noted in "Reset the matrix mixer memory" above.

Mini-Mixer Remote Controllers

The Mini-Mixer remote controllers allow you to adjust the volume of each input channel
independently of any other output channel. Each Mini-Mixer has independent controls for each input
channel, plus a master volume control that affects all the channels. The status LED near the master
volume control indicates that the unit is on. (See Status LED on page 17 for more information.) A
typical Psychologist Mini-Mixer is shown below.
Psychologist Mixer User Manual
15