Intelix Psychologist User Manual page 8

5. Connect the RCRJ12-18 cable to the PRJ12/DB9F adapter.
Because the Mini-Mixers use a 9-pin D connector cable, you'll need to use the PRJ12/DB9F adapter
to convert to the RJ12 connector used for the RCRJ12-18 cable that connects to the Matrix Mixer.
6. Connect the PRJ12/DB9F adapter to the PPS-12 power adapter. Intelix strongly recommends
that the PPS-12 is installed as close to the Mini-Mixer remote locations as possible. If the Psy-
chologist matrix is installed in a rack room away from the stage/studio location, it may be necessary to run a
length of Cat 5 UTP cable to the stage/studio location for connection to the PRJ12/DB9F adapter. Intelix
supplies an 18" cable, RCRJ12-18, for close proximity installations.
Connect the PRJ12/DB9F adapter to the PPS-12 adapter. Plug the RCRJ12-18 cable into the PRJ12/
DB9F adapter and the ReO port on the rear of the matrix.
7. Connect a PC cable into the free end of the PPS-12 adapter.
If your system requires local grounding, connect the black lead from the PPS-12 adaptor to a local
ground; a building ground as shown or a local rack ground
Plug the PPS-12 power supply into a grounded 110 VAC outlet.
Typically the PPS-12 power supply goes into the series of PC cables at the beginning of the chain, as shown
in the illustration below. For other options, or if your system has more than eight Mini-Mixers, see the Mini-
Mixer Power section on page 18.
Verify the settings of the Mini-Mixer location selectors (see page 18).
8
Psychologist Mixer User Manual
Psychologist Mixer User Manual