Trouble Shooting - Minolta Dimage Scan Elite F-2900 Instruction Manual

TROUBLE SHOOTING

SYMPTOM or MESSAGE
The computer will not start up
after connecting the scanner.
DS_Elite does not appear in
the Import drop down list.
"Could not establish
connection with scanner."
"Setting up now. Remove the
film holder."
Indicator lamp blinking
rapidly (8Hz).
"Set film properly..."
"Set 35mm film holder
properly."
"Set APS film holder properly."
"Could not recognize the
film type."
"Insufficient Memory"
"Setting up now. Remove
the film holder." appears
when the film holder is not
loaded.
SOLUTION
• Shut down the computer and all the devices in
your SCSI chain, then check the SCSI cables,
SCSI ID connection, power cord, and SCSI ID.
• Make sure the plug-in module has been
placed in the correct folder. See page 12.
• Indicator lamp is off - Turn the Dimâge Scan
Elite on, then restart your system.
• Check that the SCSI ID is not being used by
another SCSI device.
• Remove the film holder and click on OK.
• Scanner door opened during setup. Close
scanner door.
• Load film into the film holder.
• Set the correct film type.
• Set the correct film type.
• Set the film type manually.
• Increase the memory requirements for the
host application.
• If you have scanned multiple images, close
and relaunch the host application.
• Contact a Minolta Service Facility to change
the fluorescent lamp.
80