Setting Jumpers - Seagate STT20000A Product Manual

Chapter 3

Setting jumpers

Page 16
Review the jumper settings to ensure that the jumpers are properly configured for
your system. Figure 3-1 shows the location of the jumper block. Figure 3-2 shows
the jumper block.
Note: Record your jumper settings prior to installation. They are not visible after
the drive has been installed.
The default setting is Slave mode with a jumper over pin 3 and pin 4.
Your system setting may vary, so be sure to check your computer or ATAPI
controller manual to determine the proper configuration choice for your system.
Figure 3-1
Location of jumper block and connectors
Figure 3-2
Jumper block and jumper settings
(TOP OF TAPE DRIVE)
1 3 5 7
2 4 6 8
NOT USED
MASTER
SLAVE
CABLE SELECT
NOTE:
Bottom of drive shown.
JUMPER
BLOCK
PIN 1
IDE
CONNECTOR
IDE PIN 1
POWER
CONNECTOR
JUMPER ON
JUMPER OFF
Installation
STT20000A Product Manual