Chapter 3
Setting the Jumpers
Page 24
The jumper block on the Scorpion 24 provides additional access to settings for SCSI
ID, hardware data compression (HDC), enabling of the active terminator and
termination power.
For the SCSI ID jumper block settings to take effect, switches S1, S2 and S3 on the
switchbank must be in the OFF position.
Figures 10 and 11 illustrate the location of the jumper block for internal drives.
Access for Manual
Cartidge Unload
Figure 10. Location of Jumpers for Internal Model
Figure 11. Location of Jumpers for Internal Model with Rails
Jumper
Block
Pin 1
Power
Connector
SCSI
Connector
Jumper
Block
Pin 1
Power
Connector
SCSI
Connector
Installation
DAT Drives