Table of Contents
Advertisement
Section 6: Installing the Rudder and Elevator Servos
Step 2a. Install the servos in the fuselage tail section with the
output shaft to the rear as shown in the photo below. If using a
non-computer radio, be sure to install one of the servos with the
Y-harness attached in the top opening (elevator) and the other
servo with the Y-harness attached in the bottom opening
(rudder). Install the other servos in the opposite side of the
fuselage being sure to connect the servo to the other open
connector of the respective Y-harnesses. Don't forget to knot
and tape the connectors.
Note: One of the elevator servos must be a reversed servo.
18
Step 3a. Using the screws included with the servos, fasten the
servos in place. You may find it helpful to drill a 1/16" pilot hole
before installing the screws.
Note: With some servos, such as the JR 8411, it is
necessary to install the Lite-Ply servo spacers to
the outside of the fuselage to prevent the rudder servos
from touching each other.
CONTINUED
Advertisement
Table of Contents
