Russell Hobbs RHIC100 Instructions For Use Manual page 14

Press the POWER button.
8.
Press the MENU button to choose the ice cube making function, the ice (snowflake)
9.
symbol should appear on the LCD screen.
Then press the TIME button to set the time.
10
NOTE: The automatic defaulted and maximum time for Ice cubes is 60 minutes. To
adjust this press the TIME button to increase by 5 minute intervals.
11. Press the START button to begin the ice cube making process. The timer will begin to
countdown.
NOTE: The refrigerator compressor will start after the program has run for 2 minutes.
The temperature will only drop once the compressor has started
NOTE: While in operation you can increase the duration by pressing the TIME button.
It will increase in 5 minute intervals to a maximum of 60 minutes.
12. When the time has elapsed, the display will show 00:00 and the appliance will beep 10
times. Press the POWER button to switch the appliance off.
NOTE: If the appliance is not switched off after it beeps, it will continue to remain
cool for 1 hour before it switches itself off.
13. Remove the transparent lid by rotating it counter-clockwise and lift it up.
14. Remove the metal bowl from the container cavity.
NOTE: If it is difficult to remove the bowl, you can defrost it slightly using the
DEFROST FUNCTION. This will heat the edges of the bowl. To DEFROST:
a) Press the POWER button
b) Press the START button to begin the ice cream process,
c) Press the DEFROST button. 3:00 minutes will appear on the screen, after about 1
minute the time will begin to count down the time will begin to countdown.
d) It may not take the full 3 minutes, so after 1 minute, push the POWER button to
switch the defrost function off, and try to remove the bowl. If it is still too hard to
remove, repeat steps a) to d) above.
NOTE: You must be in ice cream or ice cube making mode for the DEFROST button to work.
15. Remove the ice making frame and ice cube trays from the metal bowl. If this is difficult,
hold the metal bowl by the handle in a sink on a slight angle and run cool to warm water
around the edges of the bowl for 10-15 seconds, rotating it to rinse all outside areas.
CAUTION: Do not touch the outside of the metal bowl, only use the handle.
NOTE: Do not put water directly into the container cavity.
16. Remove the ice making trays from the ice making frame (see illustration 4).
NOTE: Remove ice on a plate or in a container, or ensure your workspace is clean, as
some cubes may pop out quickly.
17. Remove ice by popping it out of the trays using both hands (see illustration 5).
Illustration 4
Illustration 5
14