Safety Notes; Technical Specifications - Funkwerk V101 Operating Instructions Manual

Safety notes

•
Mind the storage and operation temperatures for the device listed in the technical specifications. Only connect the
device when the permissible ambient operating temperature has been reached.
•
Please note that condensation may occur on or in the unit when moving it from cold to warm surroundings. Only re-
move the unit from the package when the permissible ambient operating temperature has been reached.
•
You should not make calls or connect or disconnect any lines during thunderstorms.
•
Be sure to connect all cords and cables only to their designated ports.
•
Be sure to route cords and cables so nobody can trip over them.
•
Avoid the following:
Direct sunlight
Sources of heat (for example radiators)
Electronic devices (for example stereo components, office equipment or microwave devices)
Ingress of moisture or liquids
Aggressive fluids or vapors
Dusty environment.
•
Do not use the unit in moist areas or where there is a risk of explosion.
•
Do not expose any internal parts of the unit unless you are instructed to do so by the installation and operating
manual.
•
Do not touch any connector pins with sharp metallic items or damp objects.
•
If the unit is not fixed to a surface, place it and its accessories on an anti-skid mat or equivalent.
•
Clean the unit using only a slightly dampened piece of cloth.
•
Do not use any accessories unless they have been explicitly approved.
•
The unit may only be interfaced with terminal equipment that supplies SELV voltage (Safety Extra Low Voltage)
and/or conforms with ETS 300047. This regulation is fulfilled when approved terminal devices are used as intended.
Power Supply Block
•
Use only the power supply block supplied with the product or one that has been manufactured-approved as an ac-
cessory.
•
Do not use any power supply block units with visible defects or damage (fissures, cracks in the enclosure )
Maintenance and Care
The V101 and V102 SIP VoIP telephony adapter is manufactured for normal conditions of use. When required, clean the ISDN system tele-
phone with a slightly moistened cloth, or with an anti-static cloth. Never use a solvent to clean the device! Never use a dry cloth; electrostatic
discharge may damage the electronics in the system. Under all circumstances make sure that no moisture penetrates into the enclosure and
damages the SIP VoIP telephony adapter.
Installing the Telephony Adapter
Please note that the plastic feet of your SIP VoIP telephony adapter may leave dents in sensitive surfaces, for example on furniture. The ma-
nufacturer of the telephony adapter shall not accept any liability for such kind of damage. For that reason we recommend that you place your
telephony adapter on an anti-skid surface.

Technical specifications

Power supply:
Temperature range:
Dimensions:
Weight:
12V DC / 1A through 230 V AC power supply block supplied
5° C to 40° C, 85 % max. humidity
120 x 100 x 35 mm
0.130 kg
Safety notes
1