Cables; Siting And Securing Cables; Connecting Cables - Raymarine C-series Installation Manual

87020-3.book Page 26 Tuesday, March 7, 2006 11:02 AM
26
3. Working from this corner, free the clips along the top edge of the display, then work
towards the bottom edge. Taking care to ensure that the control buttons pass
through the bezel. DO NOT lever along the top edge.
4. Carefully free the locating clips at the bottom of the bezel by lowering it away from
the unit - DO NOT USE A SCREWDRIVER FOR THIS AS IT WILL DAMAGE THE CLIPS.
5. Remove the bezel from the display.

3.3 Cables

This section details how to instal and connect all the relevant cables to your C-Series
Display:

Siting and securing cables

Please note the following:
• All cables should be adequately secured, protected from physical damage and
exposure to heat. Avoid running cables through bilges or doorways, or close to
moving or hot objects.
• Connectors should be protected from damage. If it proves necessary to pull cables
through a bulkhead or deckhead using a cord, this should be attached several
inches behind the connector. Do not attach a tie immediately behind or
around the connector.
• Acute bends must be avoided.
• Where a cable passes through an exposed bulkhead or deckhead, a watertight
feed-through should be used.
• Secure cables in place using tie-wraps or lacing twine. Coil any extra cable and tie
it out of the way.

Connecting cables

You will need to install and connect the following cables to ensure that your display
functions correctly:
• SeaTalk cable (if SeaTalk system connected).
• NMEA cable (if third party equipment, NMEA multiplexer, fast heading sensor,
RS232 interface or course computer fitted).
• SeaTalk
• Radar cable (not supplied).
• Power cable.
The cable connections are located on the back of the unit. If a trunnion bracket is being
used, all cables can be connected prior to mounting the unit. Please read the details
relating to each cable before connecting them.
2 2
cable (if Sea Talk system connected).
C-Series Displays Installation Manual