Front Hub - Arctic Cat DVX 90 2010 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
3. Install the drive chain (see Installing Drive Chain
sub-section).
4. Adjust the drive chain slack (see Adjusting Drive
Chain sub-section); then tighten the four cap
screws (from step 1) to 29 ft-lb.
INSTALLING DRIVE AXLE/REAR
HUB
1. Slowly slide the axle into the axle housing.
NOTE: The axle may have to be turned from
side-to-side slightly during installing to get the axle
through the center axle housing spacer.
2. Slide the axle through the brake disc.
3. Secure the rear sprocket to the sprocket retainer.
Tighten the three cap screws to 20 ft-lb.
www.mymowerparts.com
Back
KM207
MD2374
KM234
Back to TOC
4. Install the axle nuts securing the brake hub to the
axle (see Drive Train/Sprockets - Installing Rear
Sprockets in this section).
5. Install the drive chain (see Installing Drive Chain
sub-section).
6. Install the rear wheel/hub assemblies. Tighten the
castle nuts to 58 ft-lb; then install new cotter pins.

Front Hub

REMOVING HUB
1. Secure the ATV on a support stand to elevate the
front wheels; then remove the wheels.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
Back to Section TOC
YT197A
6
MD2364
Next
6-7