Permanent Settings In Programming Mode; Permanent Settings In Programming Mode Products; Setting The Water Hardness - Jura ENA Micro 9 One Touch Instructions For Use Manual

4 Permanent settings in programming mode

4 Permanent settings in
programming mode
Products
J
WARNING
Hot coffee, hot steam and hot water can cause
scalding. Scalding is a serious burn.
T Use extreme care when handling hot liquid
or steam.
T Allow liquid to cool down before drinking.
T In the event of scalding, rinse affected area
with cold water and seek medical attention.
T Keep children AWAY.
You can make the following permanent settings for
espresso and coffee:
U
Amount of water:
(25 ml – 240ml) (per cup)
U
Coffee strength:
NORMAL
U
Temperature:
NORMAL
(approx. 176–205 °F (80–96 °C))
You can make the following permanent settings for
latte macchiato and cappuccino:
U
Amount of milk foam:
U
Interval:
0 SEC
U
Coffee strength:
NORMAL
U
Amount of water:
(25 ml – 240ml)
U
Temperature:
NORMAL
(approx. 176–205 °F (80–96 °C))
You can make the following permanent setting for
hot water:
U
Amount of water:
(25 ml – 240ml)
Permanent settings in programming mode always
follow the same model.
Example: Permanently change the coffee strength
( ) for espresso from
FLAVOUR
.
NORMAL
18
–
0.5 OZ 8.0 OZ
,
STRONG
,
HIGH
–
3 SEC 120 SEC
–
60 SEC
,
STRONG
–
0.5 OZ 8.0 OZ
,
HIGH
–
0.5 OZ 8.0 OZ
STRONG
Precondition:
k T Press and hold the Rotary Switch until
RINSE
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to enter the
program item.
SELECT BUTTON
E Next select the button of the product for
which you would like to make settings.
No product is prepared at this point.
< T Press the Espresso button.
ESPRESSO
WATER
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to enter the
program item.
STRONG
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to confirm the
setting.
, the coffee strength is set.
OK
FLAVOUR
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to exit the program
item.
PRODUCT
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY

Setting the water hardness

E If you are using the CLEARYL Blue filter
cartridge and have activated it in program-
ming mode, you will not be able to adjust
to
the water hardness.
is displayed.
READY
appears.
PRODUCT
FLAVOUR
NORMAL
EXIT
EXIT
is
is
is
is
is