Avtech IR Done Camera User Manual page 5

MOTORIZED PAN AND SEQUENCE SETUP
On the DVR live view, click the channel which connects this camera to display in the full screen mode, and
select to show the control panel:
NOTE: Not all functions in the panel are supported for this camera. Please see the description below.
Left / Right
/
Auto mode
Preset point
To pan the camera

Click / to move the camera manually.
To set a sequence group

Step1: Click
Step2: Click
numbering you want to appoint for this point. Then, wait till you see
appearing and disappearing on the DVR status bar.
NOTE: Up to 16 preset points could be configured.
Step3: Repeat Step3 until you've added all the points you need, or click
panel.
Step4: In the "Goto" panel, select the numbering you've appointed for the preset points to check if
they're working properly.
Click to move your selection up / down / left / right, or change settings.
Click to activate the auto function.
Before using it, you need to assign a specific function that will be enabled
when "
PTZ camera.
Click to enter the PTZ preset point you want to see.
to display the preset point panel, and click
/ to move to the point you want to configure as a preset point, and click the
" is clicked. For details, please refer to the user manual of the
to go to the setting panel.
(command sending)
to return to the "Goto"