Advertisement
6
HOOD SAFETY SWITCH MOUNTING WIRE CONNECTIONS
1. Locate the BLACK/ORANGE and GRAY/RED wire from the remote start system harness.
2. Locate the wires listed below. If the hood safety switch wire has a ground ringlet terminal or a stripped end
on either wire then cut the ends of the wires so they are blunt.
3. Using the (2) supplied IDC wire taps (in hood safety switch parts bag), connect the switch wires listed
below together and crimp the IDC wire tap in place using pliers, assure that a complete and secure
connection is made.
HOOD SAFETY SWITCH WIRE
Dk. GRAY
Dk. GRAY
NOTE: Switch is not polarity sensitive.
7
GROUND CONNECTION
1. Locate the 10mm factory ground lug located in the driver's kick panel area.
(FIGURE BB)
2. Using a 10mm ratchet remove the 10mm lug bolt.
3. Re-secure the factory ground ringlet and remote start harness BLACK/
ORANGE ground wire with ringlet and tighten with a 10mm ratchet. (FIG-
URE CC)
NOTE: USING A 3/8" DRIVE TORQUE WRENCH MAKE SURE
THAT THE 10mm GROUND LUG BOLT IS SECURELY TIGHT-
EN 78-121 INCH/POUNDS.
REMOTE START HARNESS WIRE
GRAY/RED
BLACK/ORANGE
6
FIGURE BB
FIGURE CC
1031012 Rev.A 09/05
Advertisement
