Advertisement
4
REMOTE START CONTROL MODULE PREPARATION
1. Insert the supplied fuses into the remote start control module as shown in below (FIGURE W).
the fuses fit tight so use a tool handle to seat them in place if necessary.
2. Install DNA card into the remote start control module as shown below. (FIGURE X)
NOTE: Use care to assure that both rows of the multipin connectors are aligned and seated properly.
3. Plug the supplied wire harness 10-way, 24-way and 16-way connectors into the remote start control
module (FIGURE Y). Make sure the harnesses are seated completely. NOTE: The connectors will only
plug into the remote start control module one way.
4. Plug the supplied immobilizer interface 4-way connector into the remote start control module. (FIGURE
Y)
NOTE: TAPE OFF THE WHITE WIRE (IF EQUIPPED) COMING FROM THE 4-WAY CONNECTOR
(THIS WIRE IS NOT USED ON THIS SYSTEM).
DOME LIGHT
TRUNK RELEASE
HVAC 1
HVAC 2
FIGURE W
5
REMOTE ENGINE START MODULE AND IMMOBILIZER INTERFACE MOUNTING
REMOTE ENGINE START MODULE MOUNTING
1. Locate the large dashboard support bracket to the left of the steering
column.
2. Using a fiber stick to temporarily release the white harness fastener
to the left of the dashboard support brace to allow for easy place-
ment of the remote engine start control module. (FIGURE Z)
3. Using (2) supplied long tie wraps secure the remote start control
module to the left side of the dashboard support bracket. Make sure
that the remote start control module is not mounted to far down on
the bracket, this will eliminate problems with dashboard reassem-
bly. (FIGURE Z)
4. Route the dipole antenna cable (previously installed in step 2)
and plug into the 2-pin connector on the bottom of the remote
start control module.
IMMOBILIZER INTERFACE MODULE MOUNTING
1. Locate the Large dashboard support bracket to the right of the
steering column.
2. Using (1) supplied long tie wraps, secure the immobilizer interface to
the dashboard bracket. (FIGURE AA)
PK LIGHTS
DOOR LOCKS
MAIN B+
IGNITION
FIGURE X
FIGURE Z
Tie Wraps
5
FIGURE Y
FIGURE AA
1031012 Rev.A 09/05
Advertisement
