Download Print this page

Mazda 3 2004 Installation Instructions Manual page 17

2004 mazda3 remote start system with vehicle security and keyless entry
Hide thumbs Also See for 3 2004:

Advertisement

20
Shock Sensor Testing
Rearm the security system and test the shock sensor. This system is equipped with a two stage shock sensor which has
a lite-touch (warn away) trigger and a full trigger. The lite-touch trigger senses for non-damaging shock to the vehicle and
beeps the horn, the full trigger senses for potential damaging shock to the vehicle and triggers the security system. The
shock pressure needed for each trigger is tested by slapping a closed window with the open (flat) palm of your hand.
WARNING - DO NOT WEAR ANY JEWELRY (i.e.. ring or watches) ON THE HAND YOU ARE USING FOR THIS TEST,
DO NOT STRIKE THE BODY PANELS OR USE A CLOSED FIST FOR THIS TEST.
Lite-touch testing - Slap window with non-damaging pressure, increasing pressure until response is obtained- Horn
should beep one time and parking lights should flash one time once shock pressure level is obtained.
Full trigger testing - Increase pressure of slap until response is obtained but be careful not to break window - security
system should trigger. Disarm the security system.
PLACE FACTORY TRANSMITTERS IN GLOVEBOX AND ATTACH NEW 4 BUTTON REMOTE START TRANSMITTERS
TO KEYS. ALSO, PLACE USER INSTRUCTION MANUAL AND WALLET CARD IN GLOVEBOX.
21
HOOD SAFETY SWITCH ADJUSTMENT
The hood safety will need to be adjusted to shutdown the vehicle when the hood is raised to the full upright position
1. Raise and prop the vehicle's hood.
2. The hood switch cylinder should be bend away from the hood to approximately 15 degrees above parallel with the
ground. (FIGURE XX)
3. After the adjustment has been made verify that remote start system does not engage when the vehicle's hood is
open.
4. If the remote start system engages with the hood in the full upright position, the switch will need to be bent closer to
the hood.
NOTE: IT IS VERY IMPORTANT TO VERIFY THAT THE HOOD
SAFETY SWITCH PREVENTS THE REMOTE ENGINE START
SYSTEM FROM ENGAGING WHEN THE VEHICLE'S HOOD IS
IN THE FULL UPRIGHT POSITION
22
SERVICE PART NUMBER LIST
Part Number
0000-8F-H03
0000-8F-Z01
0000-8F-L02
0000-8F-H05
0000-8F-L16
0000-8F-F06
0000-8F-Z10
PowerCode®, IT-s®, Real Panic Sound® and Progressive Find® are registered trademarks of Code Systems, Inc.
Description
Hood Safety Switch Kit
Remote Start Control Module Service Part
Mazda3 Remote Start Wire Harness Service Part
Mazda3 Immobilizer Interface Service Part
Mazda3 DNA Card Software Service Part
Mazda3 Remote Start Transmitter Service Part
Dipole Antenna
17
FIGURE XX
1031012 Rev.A 09/05

Advertisement

loading

This manual is also suitable for:

0000-8f-l100000-8f-l10a