Advertisement
10
WIRE HARNESS CONNECTIONS- BRAKE SAFETY
1. Locate the brake switch connector mounted to the brake pedal assembly.
2. Temporarily unplug the connector from the brake switch and carefully remove 1"-2" inches of tape
covering the harness.
3. Place (1) supplied IDC wire tap on to the vehicle wire (using the side of the IDC wire tap that is
open on both ends).
4. Insert the wire from the remote start harness into the other side of the IDC wire tap and crimp in
place with pliers.
REMOTE START HARNESS
RED/WHITE-BRAKE SWITCH
11
WIRE HARNESS CONNECTIONS- PASSENGER UNDERDASH
1. Route the passenger kick panel harness (with six (6) loose wires)
across the driver's side lower dash using (1) supplied tie wrap,
secure the harness to the vehicle's lower center console bracket.
(FIGURE LL)
NOTE: THE BLACK/GREEN WIRE WILL NOT BE CONNECTED,
TRIM AND TAPE OFF TO PREVENT SHORTING
2. Route behind the center console across transmission hump
to the passenger's side lower dash.
3. Locate the vehicle's Passenger Junction Box (PJB) and re-
move the small plastic cover. (FIGURE MM)
4. Release the (2) twist tabs that secure the PJB and lower the
PJB to the passenger's side footwell. (FIGURE NN)
VEHICLE WIRE
RED/WHITE
10
R/W
B
R/Y
R
Brake Switch Connector
View From Harness Side
FIGURE LL
FIGURE MM
FIGURE NN
1031012 Rev.A 09/05
Advertisement
