Sony STR-DN1050 Help Manual page 153

Help Guide
MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Method 1: Setting up a wireless network using the WPS push button configuration method
If your wireless LAN router/access point has a WPS button, you can easily connect the receiver to a Wi-Fi (wireless
LAN) network.
If your wireless LAN router has an AOSS button or other easy setup button, it may support WPS. Check the operation
manual of your wireless LAN router/access point for details.
1. Select [Settings] - [Network Settings] from the home menu.
2. Select [Internet Settings].
3. Select [Wireless] (*).
The screen for selecting the IP address acquisition method is displayed on the TV screen.
*
You cannot select [Wireless] if a LAN cable is connected to the receiver.
4. Select [WPS Push].
The receiver starts searching for access point, and displays a list of up to 30 available network names (SSIDs).
5. Follow the on-screen instructions, and press the WPS button on the access point.
Message: [Push the WPS button on the access point within 2 minutes.]
WPS button on the wireless LAN router/access point
The receiver starts connecting to the network. For details, refer to the messages that appear on the TV screen.
After the network settings are complete, [
Hint
WPS (Wi-Fi Protected Setup) is a standard created by the Wi-Fi Alliance allowing you to set up a wireless network
easily and securely.
See [Information] when checking the network settings.
] lights up on the display panel.
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
142