Sony STR-DN1050 Help Manual page 374

Help Guide
MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Checking Auto Calibration results
To check error codes or warning messages received in [Auto Calibration], proceed with the following steps:
If an error code appears
Check the error and perform Auto Calibration again.
1. Select [Retry].
2. Follow the instructions on the TV screen and then press
The measurement starts in five seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
3. Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
4. Save the measurement results.
Select [Save] in step 3.
If a warning message appears
Check the warning message and select [OK]. For details on the warning messages, see
Calibration measurements."
Hint
The measurement results may vary depending on the position of the subwoofer. However, continuing to use the
receiver with that value does not cause problems.
Related Topic
List of messages after Auto Calibration measurements
to select [Start].
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
"List of messages after Auto
363