Mechanical Drawings; Panel Mount Procedure; Panel Mount Mechanicals - VarTech Systems VT170CM User Manual

Section
7

Mechanical Drawings

Model Description
VT170PM 17.0 PowerVue Panel Mount Mechanical Drawing
VT170RM 17.0" PowerVue Rack Mount Mechanical Drawing
VT170WM 17.0" PowerVue Wall Mount Mechanical Drawing
Panel Mounting Procedure
1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.
Panel Mounting Cutout
2. If access to the side of the monitor is not available following installation, attach the power and
video cables to the side of the monitor at this time.
3. Install the monitor in the prepared cutout.
4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the
sides and top/bottom of the cutout in the panel. Extra lock nuts and washers are provided.
Note: Use #10-32 nuts for mounting.
5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.
ATTENTION: Mounting nuts must be tightened to a torque of 24 inch-pounds to provide panel seal
and avoid potential damage. Vartech Systems assumes no responsibility for water or chemical
damage to the monitor or other equipment within the enclosure due to improper installation.
6. Attach the power and video cables to the side of the monitor if you have not already done so.
17.0" PowerVue User Guide
MECHANICAL DRAWINGS
23
Page(s)
24
25
26
150-059