Table of Contents
Advertisement
Section
3
The monitor is pre-aligned at the factory. However, minor adjustments are usually necessary
following installation to optimize the monitor's performance with a particular video source and
particular video formats. This section of the manual describes the operator accessible controls that
allow for such adjustment. It goes on to describe a typical setup procedure.
3.1
Operator Controls and Indicators
Operator controls include a power switch (an option), a button panel for accessing the setup
menus (OSD), and a luminance control. The VT170 Military / Marine
an LED to indicate power on. Figure 2 show a drawing of the VT170RM to illustrate the layout.
Power
Switch
• The power switch controls main power to the monitor. Power on is indicated by an
LED next to the switch.
• The OSD controls are discussed in detail in a following section.
• The luminance control controls the backlight. The range of the control is determined
by the brightness setting made with the OSD.
POWER
SOURCE
MENU
DOWN
UP
ON
Power on
indicator
Figure 2 – VT181RM front view, showing operator controls
LEFT
RIGHT
AUTO
BRIGHTNESS
OSD
Controls
8
GETTING STARTED
Series monitors have
Luminance
Control
Advertisement
Table of Contents
