Mounting The Monitor - HP ProDisplay P17A LED Backlit User Manual

3. Remove the three screws from the back of the monitor that connect the monitor panel to the
pedestal base (1), and then slide the pedestal base from the monitor panel (2).

Mounting the Monitor

The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
1. Remove the monitor panel from the pedestal base. Refer to
Base on page
CAUTION:
attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long
screws are required. Longer screws must not be used because they may damage the monitor. It
is important to verify that the manufacturer's mounting solution is compliant with the VESA
standard and is rated to support the weight of the monitor display panel. For best performance, it
is important to use the power and video cables provided with the monitor.
8 Chapter 2 Setting Up the Monitor
7.
This monitor supports the VESA industry standard 100 mm mounting holes. To
Removing the Monitor Pedestal