Setting Up Of The Dvd Player; Safety Instructions - Silvercrest KH 6517 Operating Instructions Manual

B. DVD player rear panel
h S VIDEO
: S Video output
j AUDIO OUT L/R
: Left and right audio outputs
EURO SCART
k : Scart/RGB output
CENTER
l : Output for front and centre audio channels
SL/SR
; : Output for rear, left and right audio channels
FL/FR
2)
: Output for front, left and right audio channels
2! VGA:
VGA video output
2@ COAXIAL
: Coaxial audio output
2# Power cable
OPTICAL
2$ : optical digital audio output
HDMI
2% : HDMI output
SUBWOOFER
2^
: Output for bass audio channel
2& Y, PB/CB, PR/CR
: Component video outputs
2* VIDEO
: Composite video output
C. Remote control
OPEN/CLOSE
q : Open/Close the disc tray
DIMMER
w
: Adjust the display brightness
e SKIP BACKWARDS (-)/FORWARDS (+)
r VOLUME +/-
: Volume increase/decrease
CLR
t : Clear the entry
A-B
y : Repeat sequence
MODE
u : Set the playback mode
STOP
i
: Stop playback
o PLAY/PAUSE
: Start/Suspend playback
a DVD/CARD/USB
: Change between disc playback and USB/card playback
OK
s : Confirm input
d Control buttons
ZOOM
f : Set the image enlargement
SEARCH
g
: Access the search function
ANGLE
h
: Change the camera perspective
j MUTE
: Switch the sound on/off
MARK
k : Access the bookmark function
RGB
l : Set the video signal to RGB
YUV
; : Set the video signal to YUV
2)
Battery compartment (on the rear panel)
HDMI:
2!
Set the HDMI output
2@ VIDEO
: Set the video output
TITLE
2# : Access the title menu
MENU
2$ : Access disc menu
SUBTITLE
2% : Set the subtitle
AUDIO
2^ : Set the audio language/channel
DISPLAY
2&
: Superimpose disc information
2* SETUP
: Access the OSD menu
2( SLOW
: Slow motion function
F.RWD/F.FWD
3) : Fast scan backwards/forwards
PRG
3! : Access the programme function
3@ Number buttons
STANDBY
3#
: Switch the device to standby mode

5.Setting up of the DVD player

1.
Carefully remove the DVD player and the supplied accessories from the
packing.
2.
Remove the protective foil from the display.
3.
Place the DVD player on a flat, even and firm base.
Attention!
Do not plug the DVD player into an electrical outlet at this time. Wait
until you have connected the DVD player to a television set.
In the event that you wish to change the type of video or audio connection
you must first pull the power plug from the power socket! Otherwise
the DVD player and possibly equipment connected to it could become
irreparably damaged through voltage peak strikes!

6. Safety instructions

• This device is not intended for use by individuals (including children) with
restricted physical, physiological or intellectual abilities or deficiences in ex-
perience and/or knowledge unless they are supervised by a person res-
ponsible for their safety or receive from this person instruction in how the
device is to be used.
• Children should be supervised to ensure that they do not play with the
device.
• To avoid unintentionally switching on the device pull the power cord
from the mains supply after use and before cleaning.
• Check the device and all parts for visible damage. The safety concept
can work only if the device is in a faultless condition.
• The power plug must always be easily accessible, so that the device
can be quickly separated from the mains in the event of an emergency.
Risk of electrical shocks.
• Connect the device only to correctly installed and earthed mains sockets.
Ensure that the rating of the local power supply tallies completely with
the details given on the rating plate of the device.
• Arrange for defective power plugs and/or cables to be replaced at
once by qualified technicians or our Customer Service Department.
• Arrange for customer service to repair or replace connecting cables
and/or devices that are not functioning properly or have been damaged.
NEVER submerse the device in water. Wipe it only with a slightly
damp cloth.
• Do not expose the device to rain and never use it in a humid or wet
environment.
• Ensure that the power cable never becomes wet during operation.
• You must not open the housing or repair the device yourself. Should you
do so, device safety can no longer be assured and the warranty will
become void.
• Protect the device against drip and spray water. Do not place any water-
filled vessels (e.g. flower vases) on the device.
Risk of fire!
• Do not use the device in the vicinity of hot surfaces.
• Do not locate the device in places exposed to direct sunlight, If you do,
it may overheat and become irreparably damaged.
• Do not leave the device unattended when in use.
- 5 -