Internal Mixer Mode - Reloop IQ2 MIDI Instruction Manual

5.1.2 Internal Mixer Mode (Stand Alone Mode)
In the Traktor Preferences open the menu item "Output Routing" and set the outpts as shown below:
Put the IQ2 MIDI's Channel Signal Input Selector -6- channel A to the "MIDI1" position and channel
B to the "MIDI2" position. This way the complete channels A+B are active in MIDI mode. This means
Gain, 3-band EQ and linefaders do not influence the audio signal. They will just send MIDI messages.
This mode is for users who would like to use the Traktor software mixer.
NOTES!
- For Internal Mixer Mode select the mapping "IQ2 MIDI Internal"
- with this mapping you can control the whole Traktor mixer unit virtually
- If you would like to use the loop and effect control from the External Mapping, put the FX MIDI
Switch -46- to the On position
ATTENTION! This mapping is programmed on MIDI channel 10. Make sure that your IQ2 MIDI is
assigned on MIDI channel 10. (see chapter MIDI Channel Adjustment)
38