Regulatory Compliance - Analog Devices WVGA/LCD EI3 Manual

Regulatory Compliance

The WVGA/LCD EI3 Extender Board is designed to be used solely in a
laboratory environment. The board is not intended for use as a consumer
end product or as a portion of a consumer end product. The board is an
open system design which does not include a shielded enclosure and there-
fore may cause interference to other electrical devices in close proximity.
This board should not be used in or near any medical equipment or RF
devices.
The WVGA/LCD EI3 Extender Board is in the process of being certified
to comply with the essential requirements of the European EMC directive
89/336/EEC (inclusive 93/68/EEC) and, therefore, carries the "CE"
mark.
The extender board contains ESD (electrostatic discharge) sensitive devices.
Electrostatic charges readily accumulate on the human body and equipment
and can discharge without detection. Permanent damage may occur on
devices subjected to high-energy discharges. Proper ESD precautions are
recommended to avoid performance degradation or loss of functionality.
Store unused extender boards in the protective shipping package.