Analog Devices WVGA/LCD EI3 Manual page 28

Software-Controlled Switches (SoftConfig)
used to change
the Microchip. The same procedure for
EXAMPLE_SIGNAL_C
Figure 2-2. Example of Individual FET Switches
Figure 2-3 shows the equivalent circuit to
ical switches that are in the same package. The default is shown by black
boxes located closer to the
these switches, physically move the switch to the
2-4
to a logic 1 through software that interfaces with
ENABLE_A
from
EXAMPLE_SIGNAL_D
label of the switches. In order to disconnect
ON
WVGA/LCD EI3 Extender Board Manual
disconnects
ENABLE_B
.
Figure 2-2 but utilizes mechan-
position.
OFF